Change Units on a Field Gauge LC20 and Process Meter LC30

This article will show you how to switch displayed pressure and temperature engineering units.

This article applies to all Ralston Field Gauge LC20 and Process Meter LC30 models.

1

Press and Hold the Menu/Up-Arrow Button.

2

Press the Backlight/Right-Arrow Button to scroll to UNITS

3

Press the Zero/Check Mark Button to enter the Units submenu.

The checkmark indicates the current units the Field Gauge/Process Meter is set to display. 

If you do not wish to change engineering units, press the Menu/Up Arrow Button twice to return to the main pressure screen.

4

Scroll to your desired engineering unit using the right and left buttons.

5

Press the Zero/Check Mark Button to set the new unit.

• Related Articles

• Change Engineering Units on a Field Gauge LC20

  Switch displayed pressure and temperature engineering units. 1. Press and Hold the Menu/Up Arrow Button. 2. Press the Backlight/Right Arrow Button to scroll to UNITS 3. Press the Zero/Check Mark Button to enter the Units submenu. The checkmark ...

• Calibrate the pressure sensor on a Field Gauge and Process Meter

  Do-it-yourself instructions for calibrating a Ralston digital gauge with the free FieldLab Desktop software. At the end of this process, FieldLab Desktop will automatically make any necessary adjustments to bring your Ralston gauge to acceptable ...

• Change Engineering Units on a Process Meter

  Switch displayed pressure and temperature engineering units. 1. Press and Hold the Menu/Up Arrow Button. 2. Press the Backlight/Right Arrow Button to scroll to UNITS 3. Press the Zero/Check Mark Button to enter the Units submenu. The checkmark ...

• Change Engineering Units on a Field Gauge LC10

  Quickly switch between standard pressure and temperature engineering units, add or remove standard pressure engineering units, and add custom pressure engineering units to a Field Gauge. Things you will need in order to change displayed units on a ...

• Installation instructions for panel-mounting a Process Meter LC30

  1. Cut holes in panel using diagram 2. Position LC30 over holes 3. Insert bolts from front and install nuts loosely in back 4. Tighten nut until snug, but not too tight 5. Connect pressure / temperature connections 6. Connect power via approved power ...

• Recent Articles

• How to Place an Order Using the Ralston Instruments Distributor Portal

  Purpose: This article explains how Ralston Instruments distributors can efficiently place an order using the Ralston Instruments Distributor Portal. Note that this is only available to users who are employees of authorized Ralston Instruments ...

• How to Request a Quote from Ralston Instruments

  Overview At Ralston Instruments, we aim to make the quote request process as streamlined as possible for both end users and distributors. This guide outlines the steps for each group to request a quote efficiently. For End Users End users are ...

• Calibrate the pressure sensor on a Field Gauge and Process Meter

  Do-it-yourself instructions for calibrating a Ralston digital gauge with the free FieldLab Desktop software. At the end of this process, FieldLab Desktop will automatically make any necessary adjustments to bring your Ralston gauge to acceptable ...

• How long do the keypads on the LC gauge last?

  The keypad buttons on the LC10, LC20 and LC30 gauges last typically 5-10 million cycles. This varies depending on the ambient temperature as well as the force with which the buttons are pushed.

• How National Pipe Thread (NPT) works

  NPT (National Pipe Tapered) threads are a standard used in the U.S. for connecting pipes and fittings. They are designed with a taper meaning that as you screw the male thread into the female thread, the diameter decreases and the threads become ...