1. Cut holes in panel using diagram 2. Position LC30 over holes 3. Insert bolts from front and install nuts loosely in back 4. Tighten nut until snug, but not too tight 5. Connect pressure / temperature connections 6. Connect power via approved power ...
General overview of the the interface and basic operation of the Ralston Field Gauge LC10 line of digital pressure gauges. Front 1. Power. Press and hold to power on/off. 2. LCD display. 3. High/Low/Reset. Tap to view high, and low. Press and Hold to ...
Do-it-yourself instructions for calibrating a Ralston digital gauge with the free FieldLab Desktop software. At the end of this process, FieldLab Desktop will automatically make any necessary adjustments to bring your Ralston gauge to acceptable ...
Items you will need: 2 fresh AA batteries No. 2 Phillips screwdriver No. 1 Phillips screwdriver 1. Remove screws 2. Remove back panel 3. Remove expired batteries 4. Install fresh batteries 5. Reinstall back panel * Make sure USB PCB is seated in the ...
Applies to: All Bluetooth-enabled models of Field Gauge LC20, Process Meter LC30 Ralston Field Gauge and Process Meter gauges log data to on-board memory when you start logging from the Fieldlab Mobile app. The logging interval you select determines ...
Applies to FieldLab Mobile versions 2.0 and later. This walkthrough demonstrates how to add one pressure reading. You can add as many readings to a test as needed by repeating the steps below. 1. Connect the included Bluetooth antenna(s) to the ...
This guide walks you through connecting a gauge, logging data, and retrieving a completed test run. This walkthrough uses a single gauge, but FieldLab Mobile supports multiple gauges and readings in a single test. The following guide applies to ...
Applies to FieldLab Desktop app versions 2.0 and later Learn how to: Create a custom pressure unit in FieldLab Desktop When you edit and save an existing custom unit, it will need to be manually updated on any Field Gauge or Process Meter that had ...