1. Cut holes in panel using diagram 2. Position LC30 over holes 3. Insert bolts from front and install nuts loosely in back 4. Tighten nut until snug, but not too tight 5. Connect pressure / temperature connections 6. Connect power via approved power ...
The API document allows users to communicate with a Field Gauge Model LC10 or LC20 or with a Process Meter LC30 Compatible with all LC Gauges using firmware 1.008 and above PC Serial Port Settings The recommended pc serial port settings are: Baud – ...
Before applying pressure to your Ralston gauge, confirm that the gauge is rated for higher than the max pressure that will be applied. Gauges that have been overpressured above 33% of max rating will be unable to display or log accurate pressure ...
Before applying pressure to your Ralston gauge, confirm that the gauge is rated for higher than the max pressure that will be applied. Gauges that have been overpressured above 33% of max rating will be unable to display or log accurate pressure ...
Detachable thermal probes are not interchangeable with other Field Gauges. Each temperature probe is calibrated precisely to the Field Gauge it ships with at Ralston Instruments' ISO/IEC 17025:2017 Accredited lab. To log temperature data to the ...
Connect the Bluetooth Antenna (included ) to the back of the Field Gauge or Process Meter. The Field Gauge and Process Meter Bluetooth range are limited without the provided antenna installed. Confirm that your mobile device running FieldLab Mobile ...