Quick-Start Guide and User Manual for the Process Meter LC30

Download in PDF format below.

• Related Articles

• Quick-Start Guide and User Manual for Field Gauge LC10

  Download in PDF format below.

• Installation instructions for panel-mounting a Process Meter LC30

  1. Cut holes in panel using diagram 2. Position LC30 over holes 3. Insert bolts from front and install nuts loosely in back 4. Tighten nut until snug, but not too tight 5. Connect pressure / temperature connections 6. Connect power via approved power ...

• User Manual for Field Gauge LC20

  Download in PDF format.

• Calibrate the pressure sensor on a Field Gauge and Process Meter

  Do-it-yourself instructions for calibrating a Ralston digital gauge with the free FieldLab Desktop software. At the end of this process, FieldLab Desktop will automatically make any necessary adjustments to bring your Ralston gauge to acceptable ...

• Replace Batteries in a Process Meter LC30

  Items you will need: 2 fresh AA batteries No. 2 Phillips screwdriver No. 1 Phillips screwdriver 1. Remove screws 2. Remove back panel 3. Remove expired batteries 4. Install fresh batteries 5. Reinstall back panel * Make sure USB PCB is seated in the ...

• Recent Articles

• Install Quick-test Hose on a Ralston Hose Reel

• Prevent kinks and hose jumping

  When Spooling Out When spooling the Quick-test hose out to your test area, if you are only going to spool out a portion of the hose on the reel, try applying the tension brake. The tension from the brake will prevent the remainder of the hose still ...

• Save the nitrogen in your hose reel for the next test

  If you calibrate a high number of transmitters in a week, you definitely want to conserve your nitrogen. Especially when you're so far out in the field that going back to the shop isn't an option. Blowing off 100' of nitrogen in the test hose adds up ...

• Store your Hose Reel between tests

  Each time you stow and transport your Hose Reel, reel the hose in as tightly as you can to the Hose Reel, and engage the locking pin. This will prevent the hose from uncoiling due to muscle memory and road vibrations during transport. Engage the hose ...

• Results of Calibration Test

  Results of a Calibration test using the Ralston FieldLab and supporting Desktop software.