To reset Min / Max, press the Up Button while on the main pressure screen.
Min / Max will always be reset once the FieldLab Pressure is powered down.
Reset Max/Min
When certain Test Modes are activated, FieldLab Pressure displays a running tally of the highest and lowest pressures that the gauge has detected until powered off. You can view it on the main pressure screen beside the rows titled Max and Min.
Related Articles
Find the Max Pressure of a FieldLab Digital Pressure Calibrator
Learn how to locate the max rated pressure for a FieldLab device. Exceeding the max rated pressure of your FieldLab could damage it and have an adverse affect on its functionality. Ralston Instrument offers FieldLab Pressure devices in a variety of ...FieldLab API Document
The API document allows users to communicate with a FieldLab Digital Pressure Calibrator (model FLP1). Compatible with all FieldLabs using firmware 1.126 and above PC Serial Port Settings The recommended pc serial port settings are: Baud – 9600 ...Calibrate the pressure sensor on a FieldLab
Do-it-yourself instructions for calibrating a FieldLab with free FieldLab Desktop software. At the end of this process, FieldLab Desktop will compare the readings from your Reference device and FieldLab (Zero, Mid Point, and Full Span) and if it is ...Zero a FieldLab
Reset the FieldLab pressure readout to zero when there is no pressure applied to it. Sometimes, due to atmospheric pressure, the FieldLab will show a negative or positive pressure when there isn't actually any pressure applied to it. When that ...Add Test Modes to a FieldLab
Add custom tests to a FieldLab Pressure Calibrator from FieldLab Desktop App. Note that FieldLab will not allow you to add a Test Mode if it contains a maximum pressure that exceeds the FieldLab Pressure's max pressure specifications. FieldLab ...
Recent Articles
Turn Bluetooth radio on or off on a Field Gauge LC20 or Process Meter LC30
This article applies to all Field Gauge LC20 and Process Meter LC30 models equipped with a Bluetooth radio. To determine if your gauge is Bluetooth enabled: Check the last two characters in the model number printed on the gauge. If they are "B1", the ...Operation Instructions 10,000 psi Hand Pump (Model XTHP)
Add Fluid 1. Remove the vent plug 2. Add fluid to the Fluid Chamber Acceptable fluids: Ralston Calibration Oil, mineral oil, transmission fluid, water, or alcohol. Add around 2 inches of fluid, or enough fluid to keep the bottom of the fluid ...Operation Instructions 5000 psi Hand Pump (Model QTHP)
Add Fluid 1. Remove the Vent Plug at the top of the Fluid Chamber 2. Add fluid to the Fluid Chamber Acceptable fluids: Ralston Calibration Oil, mineral oil, transmission fluid, water, or alcohol. Remove the vent plug and add around 2 inches of fluid, ...Connect one or more Ralston gauges to FieldLab Desktop App with Bluetooth
What you will need: One or more Bluetooth-enabled Ralston Gauge. How to tell if your Field Gauge has Bluetooth. The FieldLab Desktop app installed on your Windows computer. Version 1.40.4 or later. Update FieldLab Desktop to the Latest Version. 1. ...A Gauge is Overpressurized
Before applying pressure to your Ralston gauge, confirm that the gauge is rated for higher than the max pressure that will be applied. Gauges that have been overpressured above 33% of max rating will be unable to display or log accurate pressure ...