Zero a FieldLab

Reset the FieldLab pressure readout to zero when there is no pressure applied to it.

Sometimes, due to atmospheric pressure, the FieldLab will show a negative or positive pressure when there isn't actually any pressure applied to it.

When that happens you can easily reset the FieldLab by pressing the Zero button.

1

With no positive or negative pressure applied to the FieldLab, press & hold the Zero Button down until a message displays saying that the FieldLab has been Zeroed.

• Related Articles

• Quick-Start Guide and User Manual for the FieldLab Pressure Calibrator

  Download in PDF format below.

• Adjust Zoom level of Vertical Pressure Bar

  Zoom in or out on the Vertical Pressure Bar on a FieldLab Digital Pressure Calibrator. The FieldLab screen has both a numeric and graphic readout to display the current pressure. The numeric readout is very precise, while the graphic readout to ...

• FieldLab API Document

  The API document allows users to communicate with a FieldLab Digital Pressure Calibrator (model FLP1). Compatible with all FieldLabs using firmware 1.126 and above PC Serial Port Settings The recommended pc serial port settings are: Baud – 9600 ...

• Calibrate the pressure sensor on a FieldLab

  Do-it-yourself instructions for calibrating a FieldLab with free FieldLab Desktop software. At the end of this process, FieldLab Desktop will compare the readings from your Reference device and FieldLab (Zero, Mid Point, and Full Span) and if it is ...

• Put FieldLab Pressure Calibrator into Update Mode to update firmware

  Update Mode allows you to manually update the FieldLab Pressure Calibrator firmware. 1 Power off the FieldLab 2 Connect the FieldLab Pressure to FieldLab Desktop via USB 3 Power on the FieldLab Pressure while holding down both the Zero Button and the ...

• Recent Articles

• Use a FieldLab to run a valve test with manual marking of crack and reseat

  Use this article if you selected "Manual Marking of Crack and Reseat" when you created your valve test in FieldLab Desktop. The FieldLab interface is slightly different if you selected "Auto Detection of Crack and Reseat". To learn how to perform a ...

• How to obtain a Return Material Authorization (RMA) to return a product to Ralston Instruments

  If you have an issue with a Ralston Instruments product we would recommend that you go to our Knowledgebase. If you have done this and still have an issue please go to our Website at www.ralstoninst.com and browse to Support. Under Support you will ...

• Turn Bluetooth radio on or off on a Field Gauge LC20 or Process Meter LC30

  This article applies to all Field Gauge LC20 and Process Meter LC30 models equipped with a Bluetooth radio. To determine if your gauge is Bluetooth enabled: Check the last two characters in the model number printed on the gauge. If they are "B1", the ...

• Operation Instructions 10,000 psi Hand Pump (Model XTHP)

  Add Fluid 1. Remove the vent plug 2. Add fluid to the Fluid Chamber Acceptable fluids: Ralston Calibration Oil, mineral oil, transmission fluid, water, or alcohol. Add around 2 inches of fluid, or enough fluid to keep the bottom of the fluid ...

• Operation Instructions 5000 psi Hand Pump (Model QTHP)

  Add Fluid 1. Remove the Vent Plug at the top of the Fluid Chamber 2. Add fluid to the Fluid Chamber Acceptable fluids: Ralston Calibration Oil, mineral oil, transmission fluid, water, or alcohol. Remove the vent plug and add around 2 inches of fluid, ...